[gpfsug-discuss] restful way to get at SS OBJ store

[Mark.Bush at siriuscom.com]

I know in the trial VM it recommends using CyberDuck to get to the object side of scale.  Does anyone have a programmatic example of doing this?  Python would be preferred here.

Mark R. Bush | Solutions Architect
Mobile: 210.237.8415 | mark.bush at siriuscom.com
Sirius Computer Solutions | www.siriuscom.com<http://www.siriuscom.com>
10100 Reunion Place, Suite 500, San Antonio, TX 78216


This message (including any attachments) is intended only for the use of the individual or entity to which it is addressed and may contain information that is non-public, proprietary, privileged, confidential, and exempt from disclosure under applicable law. If you are not the intended recipient, you are hereby notified that any use, dissemination, distribution, or copying of this communication is strictly prohibited. This message may be viewed by parties at Sirius Computer Solutions other than those named in the message header. This message does not contain an official representation of Sirius Computer Solutions. If you have received this communication in error, notify Sirius Computer Solutions immediately and (i) destroy this message if a facsimile or (ii) delete this message immediately if this is an electronic communication. Thank you.

Sirius Computer Solutions<http://www.siriuscom.com>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://gpfsug.org/pipermail/gpfsug-discuss_gpfsug.org/attachments/20160630/565dcbbf/attachment.htm>